|
|
Post by 85t5mcss on Mar 14, 2009 20:11:21 GMT -5
I know some members here have run the strip. What's your best 1/4 mile or 1/8 mile? Best 60ft?
Personally, I don't have one right now since my Monte hasn't run in well over a year now.
|
|
|
|
Post by twomanymontes on Mar 18, 2009 19:13:18 GMT -5
I have never had a chance to run the car with this motor, When I had the stock 305, My best was a 9.92 in the 1/8th mile. This Summer I'm hoping to take Matt's car and Mine there, just to see what they will do.
|
|
|
|
Post by montemike79 on Apr 24, 2009 8:49:32 GMT -5
Best time last yr was 11.56 at 116 1.60 short time with a n/a 12.5:1 383. This yr we threw in a 11:1 413 and hoping to get a high 10 out of it, but we'll see, low 11's will do.
|
|
|
|
Post by twomanymontes on Apr 24, 2009 20:45:17 GMT -5
Sweet Mike! Keep us posted
|
|
|
|
Post by 85t5mcss on Apr 26, 2009 7:34:35 GMT -5
Didn't realize you were swapping the engine again, Mike. Share a few details with us, and some pics.
|
|
|
|
Post by montemike79 on Apr 26, 2009 21:40:04 GMT -5
ya, it's been through some changes as far as mill goes. A couple yrs back I put the 383 in, turned out to have low tension rings that made it puff a bit of blue smoke, which is normal for those rings, but I didn't like it. So yanked it out after that yr and put dome pistons in while we had it apart, made it 12.5:1, same time added the cage and 12 bolt rear. That setup ran good last yr. This yr traded that motor to my uncle for his 413, and here we are now, haven't been to the track yet to see what it does. This is the only picture I have right now of the latest mill.  |
|
|
|
Post by 85t5mcss on Apr 29, 2009 10:16:05 GMT -5
1 3/4" headers? In the frame rail? I've not been able to find them. Only up to 1 5/8", but I cant tell from pic what size they r.
|
|
|
|
Post by montemike79 on Apr 30, 2009 0:48:09 GMT -5
They are 1 3/4" from Hedman's, nicest fitting header I've seen in a G body. The hookers are stupid, there is no reason to go around the frame rail, plenty of room inside.
|
|
|
|
Post by 85t5mcss on May 1, 2009 18:12:51 GMT -5
Whats the chances u still have the number on them. All I've found is outside of frame which, like u mentioned, is stupid. I'd lift the engine to install them before accepting around the frame.
|
|
|
|
Post by montemike79 on May 2, 2009 7:05:01 GMT -5
The part no. is 65218, They do not come with exhaust flanges, and come bare. But if you want coated ones you can call Hedman and they will weld flanges on for you before they are sent to coating. This is what we did with mine.
|
|
|
|
Post by 85t5mcss on May 5, 2009 12:43:58 GMT -5
Thanks Mike
|
|
